JavaScript seem to be disabled in your browser.
You must have JavaScript enabled in your browser to utilize the functionality of this website.
Price as configured: $0.00
Certain options and accessories may extend the lead time. Please see options and accessories for details. Ships via UPS or FedEx Ground. Multiple quantities may ship via truck.
Double click on above image to view full picture
Berko | QFF4804 Ceiling Mounted Fan-Forced Heater | 4,800/3,600 Watts | 240/208 Volt 1 Phase 20.0/17.3 Amps
QFFT2 / EFFT2 Double-Pole Unit Mounted Thermostat Installation Guide
- This thermostat ships separately and must be attached to the heater at the time of installation.
- 40-90 Degree F setpoint range.
- Thermostat knob is not graduated with temperature, only warmer-cooler.
QFFT1 / EFFT1 Single-Pole Unit Mounted Thermostat Installation Guide
MS26 Installation Guide
- This is a wall-mounted remote thermostat. Wiring to connect the thermostat and heater is not included.
- 50-80 Degree F setpoint range.
- Thermostat knob is not graduated with temperature, only HI LO.
Surface Mounting Frame QFFSM / EFFSM Installation Guide
This enclosure is used to mount the heater so it extends below the ceiling.
T-Bar Frame Kit QFFTBF / EFFTBF Installation Guide
The T-Bar frame kit is used to mount the heater in a T-Bar ceiling.
Total: $0.00
Usually Ships: 2-5 Business Days. Certain Options May Extend The Lead Time.
23.0000
Grille 19.125"L x 15.75"W x 1"D Rough-In 18.25"L x 14.375"W
240/208 Volts 1 Phase 60 Hertz
16,382/12,287 BTU/HR or 4,800/3,600 Watts
150 CFM
• Dependable and quiet. • 14 gauge louver cover (Navajo White finish) with tamper resistant screws and 1/4 inch mesh screen. • Models from 1500 to 4800 Watts (5,120 to 16,382 BTU/hr.). • Room temperature is controlled by a remote wall or built-in thermostat accessory. • The heater can be ceiling mounted either recessed, surface, or in a T-bar application. The basic unit is designed for recessed installation, but is easily adapted for surface mounting with the use of the optional surface mounting frame. • Rugged steel fins are copper-brazed to the low watt density, steel sheathed, tubular heating elements which are arranged in a uniform pattern. • A thermal cutout shuts off the heater in the event of overheating. • Fan delay starts fan after heating element is warm and continues to run fan after heating element shuts off to remove residual heat. • Dual wattage units are factory wired at higher wattage and can be converted to lower wattage by removing a jumper.
You have no items to compare.
